Jump to content

Mechanical/Enclosure Development

This is the place to get support on mechanical (industrial design) development.

205 topics in this forum

  1. Temperature resistant + Food safe Rapid prototyping

    By raj,
    • 4 replies
    • 85 views

  2. The Various Stages of Industrial Design & Prototyping for a plastic enclosure

    By Bob,
    • 15 replies
    • 285 views

  3. Thermal Analysis on Fusion360

    By Rayed,
    • 7 replies
    • 44 views

  4. Thread Forming Screws

    By Shawn_Bethune,
    • 3 replies
    • 83 views

  5. through-panel momentary pushbuttons to use as actuators for tactile buttons

    By RinkerLand,
    • 6 replies
    • 43 views

  6. Types of plastic for consumer device

    By Hook,
    • 4 replies
    • 58 views

  7. Ultrasonic welding of plastic enclosures

    By dwlayton,
    • 4 replies
    • 112 views

  8. Urethane Casting in Asia?

    By Nicolás Franco,
    • 2 replies
    • 28 views

  9. Urethane Casting/Vacuum Casting suppliers

    By Nicolás Franco,
    • 0 replies
    • 21 views

  10. Urethane parts compared to injection molded parts?

    By John Teel,
    • 1 reply
    • 46 views

  11. USB Connector reliability

    By davidelvig,
    • 11 replies
    • 70 views

  12. Using magnetic pogo pin charger with 9 DOF IMU

    By anant3110,
    • 2 replies
    • 29 views

  13. Vertical system that can carry load using Stepper Motor - want help?

    By shraddha agrawal,
    • 4 replies
    • 45 views

  14. Wanted: Mechanical designer with experience in scope wearable and mobile device

    By Ksenia Mes,
    • 4 replies
    • 37 views

  15. Water holding two-piece enclosure

    By Gene,
    • 2 replies
    • 28 views

  16. Waterproof air monitoring sensor

    By johntordur,
    • 7 replies
    • 112 views

  17. waterproof pinhole reset button

    By RinkerLand,
    • 3 replies
    • 26 views

  18. Waterproofing a design

    By Bert Finkel,
    • 3 replies
    • 70 views

  19. What happens when the injection molding pressure is higher than expected range or spec ?

    By Kay,
    • 0 replies
    • 40 views

  20. What is the best practice for PCB size to the inner dimension of its enclosure?

    By Jeffrey Grossberg,
    • 16 replies
    • 91 views

  21. What is this unit in enclosure drawings?

    By cyric_ecn,
    • 2 replies
    • 40 views

  22. What kind of shapes for enclosure are cheap to make?

    By vtev,
    • 5 replies
    • 97 views

  23. What options for multi or full color screen printing?

    By Chris Hector,
    • 4 replies
    • 43 views

  24. What to look for before buying a 3D printer? 1 2

    By katela,   
    • 26 replies
    • 503 views

  25. When and How to deal with heat, cold, and condensation in an electronic device

    By RinkerLand,
    • 6 replies
    • 96 views
×
×
  • Create New...