Jump to content

Mechanical/Enclosure Development

This is the place to get support on mechanical (industrial design) development.

202 topics in this forum

  1. Types of plastic for consumer device

    By Hook,
    • 4 replies
    • 58 views

  2. Any recommendations for an exact type of plastic for a musical instrument mouthpiece?

    By Michael Shonle,
    • 10 replies
    • 58 views

  3. Off-the-shelf Plastic Enclosure

    By 4Dmario,
    • 6 replies
    • 57 views

  4. Any ideas for removable battery compartment cover that isn't too tweaky and would work with FFF 3-d printing

    By Michael Shonle,
    • 10 replies
    • 56 views

  5. Panel mount for an IDE-type ribbon cable?

    By CWB,
    • 3 replies
    • 55 views

  6. Injection Mold Part Surface Finish

    By Adam Sarafinchan,   
    • 5 replies
    • 55 views

  7. Injection Mold Fabrication

    By Bob,
    • 4 replies
    • 54 views

  8. Designing an enclosure for a board with a 3D_PIFA antenna

    By Paul Nykamp,
    • 3 replies
    • 53 views

  9. Can membrane switch overlays be applied to curved surfaces

    By RinkerLand,
    • 3 replies
    • 53 views

  10. Product Enclosure 3D Model Second Opinion/Thoughts for Cost Reduction

    By stefmoss84,
    • 3 replies
    • 53 views

  11. Aluminum Enclosure with BLE / ESP-NOW Requirements

    By Adam Sarafinchan,
    • 5 replies
    • 53 views

  12. Refining a template - brief for industrial designer

    By Renaud,
    • 6 replies
    • 52 views

  13. Rubber and silicone hardness options

    By Leon Correia,
    • 4 replies
    • 52 views

  14. Sign off criteria for Ok2TOOL & minimizing risk

    By Kay,
    • 3 replies
    • 51 views

  15. Spun Aluminum Housing for LED Spotlight

    By sean musallam,
    • 4 replies
    • 51 views

  16. Cover USB-C with Magnetic Insert to mimic MCP or Silicon Cap

    By Tedy,
    • 4 replies
    • 49 views

  17. Laboratory scissor lift design - bearings

    By Daniel Collins,
    • 4 replies
    • 48 views

  18. Screen in IP67 enclosure

    By Neil Carter,
    • 2 replies
    • 47 views

  19. Enclosure design for injection molding?

    By John Teel,
    • 1 reply
    • 47 views

  20. How to pull up an NIV Mask?

    By Ayush Sharma,
    • 1 reply
    • 46 views

  21. Are shallow recesses really neccessary for graphic overlays?

    By RinkerLand,
    • 6 replies
    • 46 views

  22. Urethane parts compared to injection molded parts?

    By John Teel,
    • 1 reply
    • 46 views

  23. Mechanical Consultation and/or Cooperation on A New Product

    By kirschmackey,
    • 2 replies
    • 46 views

  24. PCB Connectors sticking out of PCB for better enclosure design

    By Jeffrey Grossberg,
    • 9 replies
    • 46 views

  25. Vertical system that can carry load using Stepper Motor - want help?

    By shraddha agrawal,
    • 4 replies
    • 45 views
×
×
  • Create New...