Jump to content

Mechanical/Enclosure Development

This is the place to get support on mechanical (industrial design) development.

202 topics in this forum

  1. Module Connectivity Options

    By rajitha,
    • 2 replies
    • 67 views

  2. Mounting small screens

    By Alex,
    • 4 replies
    • 82 views

  3. Multi-material prototype (rigid+flex)

    By cyric_ecn,
    • 4 replies
    • 74 views

  4. Multi-turn torsion spring?

    By David Saw,
    • 1 reply
    • 19 views

  5. Need recommendation for the speaker enclosure material

    By Hao Le,
    • 5 replies
    • 63 views

  6. non-slip advice?

    By Pete,   
    • 2 replies
    • 15 views

  7. NSF and UL Certification Requirement guidance for Mechanical and Electrical Design

    By Jigar Patel,
    • 0 replies
    • 36 views

  8. off shelf low cost wifi enabled temp sensor?

    By James Scaggs,
    • 2 replies
    • 62 views

  9. Off-the-shelf Plastic Enclosure

    By 4Dmario,
    • 6 replies
    • 57 views

  10. Off-the-shelf plastic enclosure for test run

    By Loring,
    • 7 replies
    • 75 views

  11. Ordering ready-made parts vs color/sizing/thermoplastic matching

    By Szymon Krzemiński,
    • 2 replies
    • 16 views

  12. Overmolding PCB with polymer resin

    By max shirsavar,
    • 4 replies
    • 63 views

  13. Painting Process

    By STEPHANE LONKENG TOULEPI,   
    • 7 replies
    • 63 views

  14. Panel mount for an IDE-type ribbon cable?

    By CWB,
    • 3 replies
    • 55 views

  15. PCB Connectors sticking out of PCB for better enclosure design

    By Jeffrey Grossberg,
    • 9 replies
    • 46 views

  16. PCB housing with Velcro backing

    By Alex,   
    • 9 replies
    • 89 views

  17. PCB nano coatings

    By Martin Sunstrum,
    • 4 replies
    • 84 views

  18. PCB perforation tolerances

    By Pete,   
    • 5 replies
    • 23 views

  19. PLC44 C-QFN (Ceramic Quad Flat Non-Leaded Packages)

    By Markys Cain,
    • 3 replies
    • 42 views

  20. Preventing overtightening of screws holding a PCB to the front panel

    By Chris Hector,
    • 4 replies
    • 38 views

  21. Product Enclosure 3D Model Second Opinion/Thoughts for Cost Reduction

    By stefmoss84,
    • 3 replies
    • 53 views

  22. Product-Market Validation >>> Attended Local Cat Show To Test Trickle Pet Fountain, $100 for 40 interviews ;)

    By darren.riva@gmail.com,
    • 2 replies
    • 26 views

  23. Project Coblo: The mechanical engineering of the process

    By ewoud,
    • 5 replies
    • 122 views

  24. Prototyping methods for snap fit enclosures

    By jason,
    • 8 replies
    • 145 views

  25. Pulley design that can tolerate misalignment

    By Luke Mayhew,
    • 11 replies
    • 126 views
×
×
  • Create New...