Jump to content

Mechanical/Enclosure Development

This is the place to get support on mechanical (industrial design) development.

202 topics in this forum

  1. Injection Mold Part Surface Finish

    By Adam Sarafinchan,   
    • 5 replies
    • 55 views

  2. Injection molding considerations

    By Aric Caley,
    • 2 replies
    • 24 views

  3. Interesting panel solution - use aluminium cored pcbs

    By fisherman188,
    • 1 reply
    • 14 views

  4. KiCAD DXF hatch issue

    By Pete,
    • 2 replies
    • 14 views

  5. Label for customer test units

    By Jacob Thomas,
    • 9 replies
    • 113 views

  6. Laboratory scissor lift design - bearings

    By Daniel Collins,
    • 4 replies
    • 48 views

  7. LEDs Through Waterproof Enclosure

    By Henry Silva,
    • 7 replies
    • 72 views

  8. light pipes

    By jwells,
    • 2 replies
    • 68 views

  9. Liquid mister design questions

    By Brandon,
    • 7 replies
    • 90 views

  10. Locking Rotator - Any Suggestions on Design?

    By Adam Blake,
    • 3 replies
    • 32 views

  11. Looking for a non-slip material for the bottom of a case that sits on a table and can't slide around

    By RLKelly,
    • 3 replies
    • 32 views

  12. Looking for an Expert/Consultant for Gasket design for optimal acoustic performance in MEMS microphones

    By RajuK,   
    • 11 replies
    • 140 views

  13. Looking for feedback on first MVP pass

    By Shawn,
    • 7 replies
    • 111 views

  14. Looking for suggestions on button/switch design for case

    By steven wolski,
    • 3 replies
    • 39 views

  15. Low Amperage Spring Return Actuator

    By Thomas Hotchkin,
    • 1 reply
    • 156 views

  16. Low cost prototyping of a transparent led display screen

    By ZINE,
    • 2 replies
    • 45 views

  17. Low Volume Custom Electric Motor Vendor

    By nfoxman,
    • 5 replies
    • 89 views

  18. Making a product water proof and IP ratings

    By Jedi,
    • 4 replies
    • 83 views

  19. Making an NEMA 4/4X, IP67 enclosure

    By RinkerLand,   
    • 8 replies
    • 97 views

  20. Manufacturing a cup

    By Aric Caley,
    • 5 replies
    • 31 views

  21. Mechanical Consultation and/or Cooperation on A New Product

    By kirschmackey,
    • 2 replies
    • 46 views

  22. Metal Enamel insights wanted

    By Jeffrey Grossberg,
    • 8 replies
    • 44 views

  23. Metal Fabrication - USA vs Asia? Concerns? Referrals?

    By Bob,
    • 8 replies
    • 138 views

  24. Metallic look plastics?

    By Anestis Kyvranoglou,
    • 8 replies
    • 84 views

  25. MIDI melodica - MECHANICAL design

    By Štěpán Dvořáček,
    • 4 replies
    • 41 views
×
×
  • Create New...