Jump to content

Mechanical/Enclosure Development

This is the place to get support on mechanical (industrial design) development.

202 topics in this forum

  1. Fire proofing an electronic product that could cause a house fire

    By Mauricio Villalobos,
    • 12 replies
    • 135 views

  2. Cover USB-C with Magnetic Insert to mimic MCP or Silicon Cap

    By Tedy,
    • 4 replies
    • 49 views

  3. USB Connector reliability

    By davidelvig,
    • 11 replies
    • 70 views

  4. Module Connectivity Options

    By rajitha,
    • 2 replies
    • 67 views

  5. How to reduce cost of injection molds?

    By John Teel,
    • 1 reply
    • 43 views

  6. Mechanical Consultation and/or Cooperation on A New Product

    By kirschmackey,
    • 2 replies
    • 46 views

  7. Urethane parts compared to injection molded parts?

    By John Teel,
    • 1 reply
    • 46 views

  8. Enclosure design for injection molding?

    By John Teel,
    • 1 reply
    • 47 views

  9. Formula for estimating manufacturing cost for an enclosure?

    By John Teel,
    • 1 reply
    • 45 views

  10. Design of Sliding Parts 1 2

    By Gregory Harezlak,
    • 30 replies
    • 204 views

  11. Wanted: Mechanical designer with experience in scope wearable and mobile device

    By Ksenia Mes,
    • 4 replies
    • 37 views

  12. DIY Injection Molding and Mold Making

    By Adam Blake,
    • 2 replies
    • 63 views

  13. Enclosure manufacturabillity

    By Anestis Kyvranoglou,
    • 11 replies
    • 129 views

  14. Water holding two-piece enclosure

    By Gene,
    • 2 replies
    • 28 views

  15. Are shallow recesses really neccessary for graphic overlays?

    By RinkerLand,
    • 6 replies
    • 46 views

  16. Off-the-shelf Plastic Enclosure

    By 4Dmario,
    • 6 replies
    • 57 views

  17. Product-Market Validation >>> Attended Local Cat Show To Test Trickle Pet Fountain, $100 for 40 interviews ;)

    By darren.riva@gmail.com,
    • 2 replies
    • 26 views

  18. Using magnetic pogo pin charger with 9 DOF IMU

    By anant3110,
    • 2 replies
    • 29 views

  19. What to look for before buying a 3D printer? 1 2

    By katela,   
    • 26 replies
    • 502 views

  20. Small PCB Enclosure with Buttons - Looking for Design Advice

    By Graham MacRobie,
    • 8 replies
    • 75 views

  21. Being taken advantage of?

    By Bob,
    • 13 replies
    • 150 views

  22. Injection Mold Fabrication

    By Bob,
    • 4 replies
    • 54 views

  23. Urethane Casting/Vacuum Casting suppliers

    By Nicolás Franco,
    • 0 replies
    • 21 views

  24. Locking Rotator - Any Suggestions on Design?

    By Adam Blake,
    • 3 replies
    • 32 views

  25. Rubber and silicone hardness options

    By Leon Correia,
    • 4 replies
    • 52 views
×
×
  • Create New...